IPV6 VM's openvz - how to make?

You are here: Index > Virtualizor - Virtual Server Control Panel > General Support > Topic : IPV6 VM's openvz - how to make?

IPV6 VM's openvz - how to make?, Support required (2 Replies, Read 2890 times)

dubailive	# July 17, 2015, 2:04 pm
Group: Member Post Group: Newbie Posts: 6 Status:	I have Virtualizor with KVM, if I enable Multi-Virtualizor, how can I make openvz VPS from IPV6 Range? Does it involve NAT?
IP: --

IPV6 VM's openvz - how to make?

jevingala	# August 3, 2015, 9:52 am \| Post: 1
Group: Virtualizor Team Post Group: Super Member Posts: 742 Status:	Hi, You will need to add ipv6 pool and generate ips as per your requirement. It does not involve NAT. ----------------------- Regards, Virtualizor Team. http://virtualizor.com/
IP: --

IPV6 VM's openvz - how to make?

mellow-h	# August 17, 2015, 8:16 pm \| Post: 2
Group: NOC Post Group: Newbie Posts: 5 Status:	Make sure your host node has IPv6 networking enabled and assign it with an IPv6 first. Then you need to add the IP to OpenVZ. This is possibly the first mistake you are going to make after getting ipv6 block from datacenter. Make sure you can use ping6 from your host node, if you can, you simply need to add the IPv6 IPs as like IPv4 using Virtualizor.
IP: --

Jump To :

Users viewing this topic
	1 guests, 0 users.

All times are GMT. The time now is April 16, 2024, 10:57 am.

Queries: 11 | Page Created In:0.024