Bridge problem, different interface naming

You are here: Index > Virtualizor - Virtual Server Control Panel > General Support > Topic : Bridge problem, different interface naming

Threaded Mode | Print

Bridge problem, different interface naming (2 Replies, Read 1197 times)

spicyweiner	# May 25, 2016, 1:24 am
Group: Member Post Group: Newbie Posts: 3 Status:	Hello everyone, I cannot start virtnetwork because the script detects the IP configuration from "ETH0", however my Redhat box is using a different interface naming scheme, my interface is "enp5s0f1" How do I tell the script to look for enp5s0f1 instead of ETH0? I tried copying the interface config to ifcfg-eth0, didn't work. This is the error: [s23551@kvm27-kc sbin]# service virtnetwork start eth0: error fetching interface information: Device not found Error: No ip address found.
IP: --

Bridge problem, different interface naming

asim_shaikh	# May 25, 2016, 3:30 am \| Post: 1
Group: Member Post Group: Elite Member Posts: 381 Status:	Quote How do I tell the script to look for enp5s0f1 instead of ETH0? Hi, You can specify the interface in Configuration >> Slave Settings >> Network Interface. Please specify the interface in Virtualizor panel and let us know if you still face the same issue. ----------------------- Regards, Virtualizor Team http://www.virtualizor.com
IP: --

Bridge problem, different interface naming

spicyweiner	# May 25, 2016, 5:24 pm \| Post: 2
Group: Member Post Group: Newbie Posts: 3 Status:	Thanks, I missed that option.
IP: --

« Previous Next »

Threaded Mode | Print

Jump To :

Users viewing this topic
	1 guests, 0 users.

All times are GMT. The time now is April 16, 2024, 8:54 am.

Queries: 11 | Page Created In:0.035