Softaculous

Topic : Can't get Network of Guest to work

Posted By: noon-server on April 30, 2017, 4:06 pm

Hello,
Today i tested Virtualizor, and it's Greate! The UI is Great!
I Installed it on Centos 7.3 and configured it.
But the Problem: I Can't get the networking to work in the guest.
It always says: no route to host. So The Question is how i should configure it right.

I Have 2 IP-Adresses: the first is the Host IP-Adress , the second is the IP-Address for the Guest. The Netmask for both is 255.255.255.224.
I could get a seperate MAC-Address for the Guest IP if it's neceserry

I use Virtualizer KVM and the Host is hosted by Hetzner Online GmbH

How can i get it to work?
Help is appreciated.
Thanks

Posted By: chirag on May 2, 2017, 8:01 am | Post: 1

Hi,

Sir after installing the Virtualizor did you added the IPpool ?
As you will need to add the gateway and netmask information in IPpool before VM creation.

Please go through the following guide to add ippool :
http://virtualizor.com/wiki/Add_IP_Pool

As you mentioned you have the server with hetzner, you will need to add the MAC which is generated from hetzner panel for your IP.

Let us know.
If you still face the issue please open ticket with us at support@virtualizor.com

-----------------------
Virtualizor - VPS Control Panel
Follow us on Facebook

Posted By: motovnet on May 18, 2017, 12:59 pm | Post: 2

Hello guys,

I have the same problem, VPS servers are running, but no network on the VPS servers on hetzner host.

Did you find a solution?

Thanks

Posted By: chirag on May 19, 2017, 6:31 am | Post: 3

Hi,

Sir did you go through the following guide :
http://virtualizor.com/wiki/NAT

Let us know

-----------------------
Virtualizor - VPS Control Panel
Follow us on Facebook