Topic : Incomplete UBC settings after saving.

Posted By: wolke on December 9, 2017, 2:24 pm

when saving UBC settings, some of the limits does not get saved in virtualizor. When reopening the UBC settings page for a vps , some limits are blank. Subsequent tries to save the -unedited- page result in an errormesages. (Screenshot attached.)

Posted By: Joshua2504 on December 9, 2017, 8:00 pm | Post: 1
I tried from my side and I can confirm this issue; it doesn't seem to come from your side.


TREUDLER - High-Performance KVM NVMe Virtual Servers in 10 locations world-wide

Posted By: wolke on December 10, 2017, 8:45 am | Post: 2
As far as I know, the settings are the ones where OpenVZ recommend to set the limit to the same value as the barrier.

The limits can be set to "unlimited" in Virtualizor and then they will be saved. But then these limits are "unlimited" in the conf file also.

Until this is fixed, we need to edit settings directly in the conf file of the container found at /etc/vz/conf

Powered By AEF 1.0.8 © 2007-2008 Electron Inc.