Softaculous

Topic : viifbr0 cannot work in dhcp mode

Posted By: haig233 on October 16, 2023, 3:18 pm

Hello, once my server starts the viifbr0 bridge, my physical host (physical server) will not be able to access any network connections and dns resolution under SSH. As for the virtual machine, I haven't tried it yet, but there is a high probability that I will not be able to access the network.

My physical server uses dhcp working mode. The machine is directly connected to the modem using a network cable. The IP address will be reassigned every time the modem is started, so there is no way to directly set a static IP and fixed gateway on the physical server.

Please tell me how to solve this problem?

Posted By: jevingala on October 17, 2023, 6:32 am | Post: 1

Hi,

so there is no way to directly set a static IP and fixed gateway on the physical server.
>> Does it not allows to set static network configuration in OS on the server ?

It should work that way.

-----------------------
Regards,
Virtualizor Team.
http://virtualizor.com/

Posted By: innocentskeg on January 22, 2024, 3:21 am | Post: 2

doodle jump
____ _____
Hello,
Your network connectivity troubles appear to be due to the setup of the viifbr0 bridge. Here are a few methods to troubleshoot and perhaps solve the issue:
Double-check the network setup on your actual server. Make sure that the interface linked to the modem is configured to utilize DHCP to receive an IP address.
Review the settings of the Viifbr0 bridge. Make sure it's properly configured. Incorrect bridge settings might cause network problems.
To check the status of your DHCP client on your physical server, use the systemctl state client. This service obtains IP addresses from the DHCP server.