Softaculous

Topic : Cannot create VPS

Posted By: nbucko on May 27, 2020, 5:39 pm

I'm trying virtualizor out and have it installed as master with a proxmox host added. Whenever I try to create a VPS I get an error that it could not create the VPS and nothing else. Here is what I get:

Quote

Downloading OS Template from Master
Creating Disk : 1
There was an error in creating the VPS. Click here to reinstall the Virtual Server

Where can I get more information about why it failed?

Posted By: nbucko on May 27, 2020, 6:11 pm | Post: 1

Digging further I found the tasks within virtualizor. I see a task, Creating Disk : 1, that is stuck at 26%. Not sure where to go from here.

Posted By: jevingala on May 29, 2020, 6:33 am | Post: 2

Hi,

Is proper Proxmox Server name and password is set for that server in Configuration->Slave settings ?
Also is the storage name on Virtualizor panel same as seen in Proxmox panel ?

-----------------------
Regards,
Virtualizor Team.
http://virtualizor.com/

Posted By: nbucko on May 29, 2020, 1:48 pm | Post: 3

I'm using the IP address for the name under slave settings and I put the password in again just to be sure. The storage name on both do match. Still no luck.

Quote From : jevingala May 29, 2020, 6:33 am

Hi,

Is proper Proxmox Server name and password is set for that server in Configuration->Slave settings ?
Also is the storage name on Virtualizor panel same as seen in Proxmox panel ?

Posted By: vietcombank on May 29, 2020, 2:30 pm | Post: 4

Did you try reinstall your server?

-----------------------
Try the best VPS: https://hawkhostcoupon.webflow.io

Posted By: nbucko on May 29, 2020, 3:19 pm | Post: 5

I did click to re-install but it still fails at the same point.

Quote From : vietcombank May 29, 2020, 2:30 pm

Did you try reinstall your server?

Posted By: jevingala on May 30, 2020, 7:08 am | Post: 6

Hi,

I'm using the IP address for the name under slave settings
>> Provide output of pvesh get nodes command from that server

-----------------------
Regards,
Virtualizor Team.
http://virtualizor.com/

Posted By: nbucko on May 31, 2020, 11:41 am | Post: 7

See attached.

Quote From : jevingala May 30, 2020, 7:08 am

Hi,

I'm using the IP address for the name under slave settings
>> Provide output of pvesh get nodes command from that server

Posted By: jevingala on June 1, 2020, 6:41 am | Post: 8

Hi,

Can you try setting Server name as pm01 in Slave settings and then check.

If it still gives issues, then you will need to open a ticket with access details of that server :

https://softaculous.deskuss.com/open.php

-----------------------
Regards,
Virtualizor Team.
http://virtualizor.com/

Posted By: nbucko on June 4, 2020, 3:19 pm | Post: 9

Quote From : jevingala June 1, 2020, 6:41 am

Sorry for the delay. Thank you for that information. I was using the full hostname of the server, didn't realize that the names in the different areas needed to match up. Everything is working as expected now.