Welcome Guest. Please Login or Register  


You are here: Index > Virtualizor - Virtual Server Control Panel > General Support > Topic : The viifbr0 is not started. Please run service virtnetwork start



Threaded Mode | Print  

 The viifbr0 is not started. Please run service virtnetwork start, No matter what... (4 Replies, Read 23335 times)
Dumby1
Group: Member
Post Group: Newbie
Posts: 1
Status:
No matter what guide read, what do my server either ends up having to be reinstalled or just get  The viifbr0 is not started. Please run service virtnetwork start..


Like did exactly what all the guides said and nothing works. Any suggestions of a decent guide?
IP: --   

The viifbr0 is not started. Please run service virtnetwork start
asim_shaikh
Group: Member
Post Group: Elite Member
Posts: 381
Status:
Quote
The viifbr0 is not started. Please run service virtnetwork start..


Can you please paste the error message displayed, when you run "service virtnetwork start" ?

Can you please confirm that you have specified the primary network inetface in Virtualizor if it is other than eth0, in Configuration >> Slave Settings  >> General settings ?

Also can you confirm that IP, NETMASK and GATEWAY are specified  in your network interface file ?
If you want you can also create a permanent bridge file  by following the guide in the link below :

http://virtualizor.com/wiki/KVM_Bridge


-----------------------
Regards,
Virtualizor Team
http://www.virtualizor.com
IP: --   

The viifbr0 is not started. Please run service virtnetwork start
motovnet
Group: Member
Post Group: Newbie
Posts: 4
Status:
What turned out to be the solution? I have the same problem on CentOS 6.
IP: --   

The viifbr0 is not started. Please run service virtnetwork start
abhijeetm
Group: Virtualizor Team
Post Group: Working Newbie
Posts: 97
Status:
Hi,
Possible reasons for viifbr0 not getting created :
1. The primary interface name is different than that of default (eth0)
-- If this is so, then specify Network Interface name under Admin Panel > Configuration > Master/Slave Settings > Network Interface

2. If eth0 already exist and it do not have a gateway and IP assigned
-- If your server's network is working then this can be the case when you have another NIC with public IP.  Specify this NIC to Virtualizor by following above  point 1.

3. Your server's default gateway is not in the same network as your server's IP range.
-- If this is so, then you will have to manually fill in network details under /usr/local/virtuailzor/universal.php file specifying
IP, Netmask, Gateway and interface name.

If all above mentioned points are not cause of your network issue, then create a ticket with Virtualizor to troubleshoot it further.
IP: --   

The viifbr0 is not started. Please run service virtnetwork start
komalselva
Group: Member
Post Group: Newbie
Posts: 3
Status:
the problem is everyone is executing
service virtnetwork start
after updating settings. it will not work if the virtnetwork is already started. You should do
service virtnetwork restart
or
service virtnetwork stop
then
service virtnetwork start
I spent few hours and few reinstalls of the OS to solve this issue. Even the help documents only mentions service virtnetwork restart.

-----------------------
IndicServer Internet Services
IP: --   

« Previous    Next »

Threaded Mode | Print  



Jump To :


Users viewing this topic
1 guests, 0 users.


All times are GMT. The time now is March 28, 2024, 5:04 pm.

  Powered By AEF 1.0.8 © 2007-2008 Electron Inc.Queries: 11  |  Page Created In:0.335