Group: Member
Post Group: Newbie
Posts: 2
Status:
|
I have setup multiple Virtualizor servers in the past with no issue, but now I am getting this when creating a vps: "The viifbr0 is not started. Please run service virtnetwork start"
Here is my netplan file bridge:
bridges:
viirbr0:
interfaces: [ enp1s0f0 ]
addresses:
- 5.39.223.0/24
gateway4: 5.39.223.1
nameservers:
addresses:
- 8.8.8.8
- 8.8.4.4
version: 2
Here is my ip link show results:
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN mode DEFAULT group default qlen 1000
link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
2: enp1s0f0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq master viirbr0 state UP mode DEFAULT group default qlen 1000
link/ether 0c:c4:7a:15:f5:ce brd ff:ff:ff:ff:ff:ff
3: enp1s0f1: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc mq state DOWN mode DEFAULT group default qlen 1000
link/ether 0c:c4:7a:15:f5:cf brd ff:ff:ff:ff:ff:ff
5: virbr0: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc noqueue state DOWN mode DEFAULT group default qlen 1000
link/ether 00:00:00:00:00:00 brd ff:ff:ff:ff:ff:ff
6: viirbr0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc noqueue state UP mode DEFAULT group default qlen 1000
link/ether 0c:c4:7a:15:f5:ce brd ff:ff:ff:ff:ff:ff
I have my network interface set to enp1s0f1 within virtualizor master settings.
Any ideas to what could be the problem?
|