NAT not working

You are here: Index > Virtualizor - Virtual Server Control Panel > General Support > Topic : NAT not working

NAT not working, Unable to add ip pool with NAT (3 Replies, Read 5447 times)

mtahit5060	# May 5, 2018, 9:26 pm
Group: Member Post Group: Newbie Posts: 2 Status:	I tried to add an IP Pool , but it gave error "cannot create NAT network" but the pool was added. when i try to delete it, now it says "There was error while destroying the NAT network" I did the same installation fresh one, more than 5 times, i have setup everything as defined in guide , still getting this issue
IP: --

NAT not working

jevingala	# May 7, 2018, 6:47 am \| Post: 1
Group: Virtualizor Team Post Group: Super Member Posts: 742 Status:	Hi, Can you please provide access to your server in ticket so that we can check the issue. ----------------------- Regards, Virtualizor Team. http://virtualizor.com/
IP: --

NAT not working

mtahir5060	# May 8, 2018, 9:02 pm \| Post: 2
Group: Member Post Group: Newbie Posts: 1 Status:	the Team cannot even Fix my License to one IP. i asked them to move my license to another IP and the IP keeps changing back to another IP, which i dont need. its been a week and i cannot even use virtualizor due to Stupid licensing problems.
IP: --

NAT not working

jevingala	# May 9, 2018, 9:41 am \| Post: 3
Group: Virtualizor Team Post Group: Super Member Posts: 742 Status:	Hi, Virtualizor will fetch license based on your server's outgoing ip. If the server's outgoing ip changes, then it will change the license on panel. Can I get ticket id so that I can check your issue ? ----------------------- Regards, Virtualizor Team. http://virtualizor.com/
IP: --

Jump To :

Users viewing this topic
	1 guests, 0 users.

All times are GMT. The time now is April 19, 2024, 5:13 am.

Queries: 11 | Page Created In:0.031