Posted By: nbucko on May 27, 2020, 6:11 pm | Post: 1 |
Digging further I found the tasks within virtualizor. I see a task, Creating Disk : 1, that is stuck at 26%. Not sure where to go from here. |
Posted By: jevingala on May 29, 2020, 6:33 am | Post: 2 |
Hi,
Is proper Proxmox Server name and password is set for that server in Configuration->Slave settings ? Also is the storage name on Virtualizor panel same as seen in Proxmox panel ? ----------------------- Regards, Virtualizor Team. http://virtualizor.com/ |
Posted By: vietcombank on May 29, 2020, 2:30 pm | Post: 4 |
Did you try reinstall your server?
----------------------- Try the best VPS: https://hawkhostcoupon.webflow.io |
Posted By: nbucko on May 29, 2020, 3:19 pm | Post: 5 |
I did click to re-install but it still fails at the same point.
Quote From : vietcombank May 29, 2020, 2:30 pm Did you try reinstall your server? |
Posted By: jevingala on May 30, 2020, 7:08 am | Post: 6 |
Hi,
I'm using the IP address for the name under slave settings >> Provide output of pvesh get nodes command from that server ----------------------- Regards, Virtualizor Team. http://virtualizor.com/ |
Posted By: jevingala on June 1, 2020, 6:41 am | Post: 8 |
Hi,
Can you try setting Server name as pm01 in Slave settings and then check. If it still gives issues, then you will need to open a ticket with access details of that server : https://softaculous.deskuss.com/open.php ----------------------- Regards, Virtualizor Team. http://virtualizor.com/ |
Posted By: nbucko on June 4, 2020, 3:19 pm | Post: 9 |
Quote From : jevingala June 1, 2020, 6:41 am Hi,
Can you try setting Server name as pm01 in Slave settings and then check. If it still gives issues, then you will need to open a ticket with access details of that server : https://softaculous.deskuss.com/open.php Sorry for the delay. Thank you for that information. I was using the full hostname of the server, didn't realize that the names in the different areas needed to match up. Everything is working as expected now. |