Hello,
I'm trying to set up virtualizor on Hetzner. I have done this previously without any problems. Now I keep getting the warning when logging to virtualizor panel:
Quote The viifbr0 is not started. Please run service virtnetwork start
My ifcfg-eth0
Code DEVICE=eth0
BOOTPROTO=none
ONBOOT=yes
HWADDR=d4:3d:7e:f8:ec:09
IPADDR=xxx.xxx.14.241
NETMASK=255.255.255.255
SCOPE="peer xxx.xxx.14.225"
GATEWAY=xxx.xxx.14.225
#IPV6INIT=yes
#IPV6ADDR=2a01:4f8:201:73f0::2/64
#IPV6_DEFAULTGW=fe80::1
#IPV6_DEFAULTDEV=eth0
My route-eth0
Code ADDRESS0=0.0.0.0
NETMASK0=0.0.0.0
GATEWAY0=xxx.xxx.14.225
which is "identical" to my other servers that run virtualizor without any problem.
I open a ticker on virtualizor (#829018) and after 3-4 hours I got the reply:
Quote Sir i have found that the netmask of the server is 255.255.255.255 you have to change it 255.255.255.0 as the 255 in the dose not allows to create the bridge .
Please ask dc to set some other network mask .
Please done please run service virtnetwork start from cli to start the bridge.
In a strange way the VPS that I created on this server are functioning without any problem.
My server runs Centos 6.5 x64.
Why is this happening? Have Hetzner changed something that makes it imposimple for virtualizor / KVM to work on netmask 255 or is it just lack of knowldge on behalf of Virtualizor techicians or something else?
Will Hetzner be able to change the Netmask only for my server or will they just laugh while reading my ticket to them?
Anyone else had that issue and got it solved? How?
Thank you in advance.
Best regards,
Spyros
----------------------- hostivate.com VPS hosting services |