Group: Member Post Group: Newbie
Posts: 3
Status:  |
Hello everyone,
I cannot start virtnetwork because the script detects the IP configuration from "ETH0", however my Redhat box is using a different interface naming scheme, my interface is "enp5s0f1"
How do I tell the script to look for enp5s0f1 instead of ETH0?
I tried copying the interface config to ifcfg-eth0, didn't work.
This is the error:
[s23551@kvm27-kc sbin]# service virtnetwork start
eth0: error fetching interface information: Device not found
Error: No ip address found.
|
May 25, 2016, 1:24 am
