About the IPV6 on server

You are here: Index > Virtualizor - Virtual Server Control Panel > General Support > Topic : About the IPV6 on server

About the IPV6 on server (2 Replies, Read 9423 times)

Sink	# February 10, 2021, 1:29 pm
Group: Member Post Group: Newbie Posts: 2 Status:	Hello! When I try to install Virtulizor on the server, ipv6 becomes unavailable. Just like This: PING google.com(dfw28s23-in-x0e.1e100.net (2607:f8b0:4000:817::200e)) 56 data bytes From server (2610:150:8000:db::44:55) icmp_seq=1 Destination unreachable: Address unreachable However, it is available before installation, and I had checked the ifcfg-eth0 didnt have any change at all... I have tried many times but still the same problem, wish you can help me, thank you a lot.
IP: --

About the IPV6 on server

Sink	# February 10, 2021, 2:38 pm \| Post: 1
Group: Member Post Group: Newbie Posts: 2 Status:	I think it might be because my bridge settings are not correct... So... How to set up the bridge for IPV6 my /etc/sysconfig/network-scripts/ifcfg-intbr0: DEVICE=intbr0 ONBOOT=yes TYPE=Bridge BOOTPROTO=static IPADDR=192.168.1.1 NETMASK=255.255.255.0
IP: --

About the IPV6 on server

jevingala	# February 11, 2021, 9:11 am \| Post: 2
Group: Virtualizor Team Post Group: Super Member Posts: 744 Status:	Hi, Virtualizor creates a bridge(viifbr0) using virtnetwork service. What you can do is create a permanent bridge, as per this guide, with ipv4 and ipv6 in it and avoid virtnetwork service and then check : https://www.virtualizor.com/docs/admin/kvm-bridge/#making-the-bridge-permanent ----------------------- Regards, Virtualizor Team. http://virtualizor.com/
IP: --

Jump To :

Users viewing this topic
	1 guests, 0 users.

All times are GMT. The time now is May 25, 2024, 10:48 pm.

Queries: 10 | Page Created In:0.024